Tascam s-1641
Important safety precautions 10 tascam us-1641 3 – installation 10 tascam us-1641 system requirements windows supported operating system: 32-bit windows xp sp2 or 32-bit vista recommended system: cpu: pentium4 or athlon 1.4 ghz or faster (or equiva- lent processor) ram: 512 mb or more memory hdd: 1. (please note that this connector supports only usb 2.0 connection.) a digital in jack this is an rca connector that inputs a stereo. Important safety instructions tascam us-1641 2 – features of the us-1641 tascam us-1641 rear panel 0 usb connector use a usb cable to connect this to the host computer. 2 usb indicator lights up green to indicate a valid usb connection to the hos.
The power indicator lights up red when the power is on. Important safety precautions tascam us-1641 2 – features of the us-1641 tascam us-1641 front panel 1 power switch and indicator turns the power to the unit on or off.
Important safety instructions tascam us-1641 1 – introduction tascam us-1641 beware of condensation if the unit is moved from a cold to a warm place, or used after a sudden temperature change, there is a danger of condensation vapor in the air could condense on the internal mechanism, making correc.
Tascam s 1641 manual#
Please read this owner’s manual carefully before using the unit in order to maximize your use of all its features. Important safety precautions tascam us-1641 1 – introduction thank you very much for purchasing the tascam us-1641 16x4 96 khz/24 bit usb2.0 audio/midi inter- face. Allow at least 10 cm (4 in) at the rear of the unit for ventilati. Note leave 1u of space above the unit for ventilation. Remove the feet of the unit before mounting. Tascam us-1641 rack-mounting the unit use the supplied rack-mounting kit to mount the unit in a standard 19-inch rack, as shown below.
Tascam s 1641 install#
Install in accordance with the manufacturer. Important safety instructions tascam us-1641 1 read these instructions. The lightning flash with arrowhead symbol, within equilateral triangle, is i. Tascam us-1641 the exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. From my experimentation, "Low", "High", and "Highest" all work OK.D01002220a us-1641 16x4 96k/24-bit usb audio/midi interface » owner's manual. Each setting has a fixed buffer size, and unfortunately "Normal latency" (the default) corresponds to a buffer size not supported by PT. You've probably found this already, but for anyone reading along that hasn't, use the "Audio Performance" setting on the US-1800 control panel. Or am I just flogging a dead horse with this ancient (8 years? ) device.
Tascam s 1641 drivers#
If drivers have been loaded for this device previously for use with the old DAW, are they where they need to be for PT? On my old DAW, buffer size was selected within the DAW. Though the load screen occaisionally notes the prsence of the TASCAM, complete load fails because an error message indicates that an unsupported buffer size is configured. However, I have installed PT11 on my home computer on which I previously had installed another DAW(since mercifully euthanized), running with a TASCAM 1641.
PT11 is installed on the studio computer, interfacing with a UA Apollo Quad.